Enlight EN-7100 User Manual

Fig:4

Remove fan housing by using thumbs to 

unfasten clips and place fan in housing 

(Fig. 4).  Snap fan housing back into the 

chassis.  Connect fan and speaker wiring 

to M/B as instructed in M/B user 

manual (After M/B is installed!).

Install 3.5" HDD and FDD (floppy)

A. Squeeze tabs on side and remove 3.5"    

     drive cassette (Fig. 5). Slide HDD into 

     cassette and fasten with coarse thread 

     flat head screws. Make sure EMI clip is 

     In place.  

B. Slide floppy into the same cassette and 

     fasten with fine thread flat head screws.

     Then slide cassette back in to drive bay   

     And snap in to place.

A. Fasten slide guides to the sides of 

     CD-ROM  (DVD or 5.25" FDD) using 

     fine thread flat head screws (Fig. 6). 

B. Slide CD-ROM in to 5.25" bay and  

     snap in to place (Fig. 7).. 

Fig:5

Fig:6

Fig:7

Series EN-7100

Fig:3

Fig:1

Fig:2

***Important-First please check your model number before proceeding.  The user 

manual is set up to correspond to the model number and installation will vary 

depending on the model.

Required tools: Phillips head screwdriver, pliers 

Place case on edge of table (Fig.1). With one 

hand holding top of chassis, pull quickly from 

the bottom of the bezel to remove it (Fig. 2).  

**Note-It might require some force to remove 

due to the snug fit to the chassis.

Remove screws.  Place hands on sides of 

top cover and thumbs firmly on chassis.  

Slide top cover towards you 1" (Fig. 3).   

Spread sides and lift straight up to remove.