Enlight EN-7230 User Manual

A. Fasten slide guides to the side of

     CD-ROM  (DVD or 5.25" FDD)   

     using fine thread flat head screws 

     (Fig 7). 

B. Slide CD-ROM in to 5.25" bay and 

     snap in to place (Fig 8).

Fig:5

Fig:6

Fig:7

Remove fan housing by using thumbs to 

unfasten clips and place fan in housing (Fig 5). 

Snap fan housing back into the chassis.  

Connect fan and speaker wiring to M/B as 

instructed in M/B user manual

(After M/B is installed!).

A. Squeeze tabs on sides 3.5" 

     drive cassette (Fig.6) and pull 

     out to remove.   Slide HDD into 

     cassette and fasten with coarse 

     thread flat head screws. 

B. Slide floppy into the same 

     cassette and fasten with 

     fine thread flat head screws.

Fig:8

Series EN-7230

Remove screws and slide right side 

towards you 1" and lift up (Fig. 3).  

Remove the left side in the same 

way.  Lift top panel and remove 

from hooks as shown (Fig 4).

Remove screws and slide       

cover towards you 1".  

Spread sides and lift 

vertically to remove.

Fig:2

Fig:4

***Important-First please check your model number before proceeding.  The user 
manual is set up to correspond to the model number and installation will vary 
depending on the model.

Required tools: Phillips head screwdriver, pliers 

***(Photos shown may vary according to model number)

Place case on edge of table. (Fig.1) 

With 1 hand holding top of chassis, 

pull in quick motion from the bottom 

of the bezel to remove it (Fig. 2).  Be 

careful not to pull bezel off before 

hinges are disengaged. 

 **Note-it might require some force 

to remove due to the snug fit to the 

chassis.

Fig:1

Fig:3