Emerson Liebert PSA Line-Interactive UPS 500-1500VA User Manual
Installing the Software
16
Liebert
®
MutiLink
®
5.2.3 Define Serial Port Connection
If the connection method you selected is Serial port on computer [computer name] (below left
• Specify the serial port of the computer to which the UPS is connected by choosing from the drop-
down list of ports, shown below right. If the port you wish to use is not in the drop-down list, type
the designation into the box.
For further information, see serial port information for your operating system in
• If the UPS and computer are not yet linked by a cable or if the UPS uses Contact Closure
connection, a message window prompts you for the type of connection to be used.
Refer to 3.1 - Connecting host computer, UPS and targeted clients before making a
Refer to 3.1 - Connecting host computer, UPS and targeted clients before making a
selection. The two types of connections are:
• Contact-closure communications—for UPS models, see Table 1
• Serial communications—for UPS models, see Table 1
• Serial communications—for UPS models, see Table 1
Each type requires a custom cable. These cables can be made or purchased.
• To make a cable, see Appendix B - Making Your Own Liebert MultiLink UPS Cable.
• To buy a cable, see Appendix E - Ordering Parts.
• To buy a cable, see Appendix E - Ordering Parts.
NOTE
Make sure that the specified port is a serial port on the computer, not on a terminal expander.
Make sure that the specified port is a serial port on the computer, not on a terminal expander.
For a Contact Closure UPS, this port must support the modem control lines shown in Table 12
in Appendix B - Making Your Own Liebert MultiLink UPS Cable. For a serial
connection UPS, see Table 11.