Emerson DECT 6.0 EM6113 User Manual

6

2

3

1

4

5

6

7

1. Charging / in use (flashing)
2. Display for answering machine
3. Power
4. Key for answering machine:

    

5. Paging key
6. Microphone 
7. Charging contacts for handset

briefly: check number of rings

decrease speaker volume 

press and hold: set number of rings

briefly: turn answering machine on/of   stop playback

press and hold: select OGM

briefly: play OGM

back to previous message

press and hold: record OGM

(during settings: decrease value)

briefly: check remote PIN 

increase speaker volume 

press and hold: set remote PIN

briefly: confirmation “Delete all“

Delete current message

press and hold: delete all messages

briefly: (no function)

skip to next message

press and hold: record memo

(during settings: increase value)

briefly: playback messages

Pause 

17

●  Check or repeat installation steps:

    - Make sure the base power is connected to a working electrical outlet.

    - Make sure the telephone line cord is connected to the base and the wall

    jack.

●  Connect another phone to the same jack.  If it doesn’t work, the problem

    might be your wiring or local service.

●  The handset may be out of range of the base.  Move closer to the base.

●  Make sure the battery is properly charged (for 16 hours).

●  Make sure the battery in the handset is properly installed.

●  The handset should beep when you press the TALK button, and the charge

    indicator on the base should lit when the handset rests in the cradle, If

    not, the battery may need to be charged.

●  Place handset in charge cradle for at least 20 seconds to reset the unit.

●  Make sure the ringer switch is set to the ON position.

●  The handset may be out of range of the base.  Move closer to the base.

●  Check for a dial tone.
You experience static, noise, or fading in  and out

●  The handset may be out of range of the base.  Move closer to the base.

●  Make sure the base is not plugged into an electrical outlet with another

    household appliance.  If necessary, relocate the base.

● Charge the battery for 16 hours.

When the desired telephone number is displayed, press the          button.  Select SAVE 
TO PB

 if necessary and press the         button.  Enter the name and press the          

button.  Edit the telephone number if necessary.  Press  the         button for deleting the 
last character or press and HOLD for deleting the whole number.  You can enter a dialing 
pause (approximately 3 seconds) by pressing the          button.
Press the        button again to select a melody for the entry.
Press the        button to store the entry. 

When the desired telephone number is displayed, press the          button.  
Select DELETE or DELETE ALL if necessary and press the           button.  The entry or all 
entries will be deleted.

PAUSE