Electrolux FN620K User Manual

TILLER

TO ADJUST HANDLE HEIGHT (See Fig. 15)

Factory assembly has provided lowest handle height. Se lect
handle height best suited for your tilling conditions. Handle
height will be different when tiller digs into soil.
• If a higher handle height is desired, loosen the four

nuts securing handle panel to engine brackets.

• Slide handle panel to desired location.
• Tighten the four nuts securely.

HANDLE
PANEL

ENGINE
BRACKETS

NUTS (ALSO 2
ON LEFT SIDE
OF TILLER)

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into
contact with plug.

SERVICE AND ADJUSTMENTS

TINE ARRANGEMENT

Your outer tines can be assembled in several different ways
to suit your tilling or cultivating needs.

CAUTION: Tines are sharp. Wear
gloves or other protection when han-
dling tines.

NORMAL TILLING - 17" PATH (See Fig. 16)
• Assemble holes “A” in tine hubs to holes “B” in tine

shaft.

FIG. 16

FIG. 17

CLEVIS
PIN

INNER TINE

OUTER TINE

HAIRPIN CLIP

MID-WIDTH TILLING - 15" PATH (See Fig. 17)
• Assemble holes “A” in tine hubs to holes “C” in tine

shaft.

FIG. 15

INNER TINES ONLY

FIG. 18

NARROW TILLING - 10-1/4" PATH (See Fig. 18)
• Remove outer tines.

NARROW CULTIVATING - 12-1/2" PATH (See Fig. 19)
• Remove inner tines.
• Assemble holes “A” in tine hubs to holes “C” in tine

shaft.

FIG. 19

FIG. 20

EDGING - 9-5/8" PATH (See Fig. 20)
• Remove inner tines.
• Assemble holes “A” in tine hubs to holes “D” in tine

shaft.