CyberPower RMCARD303 Leaflet

QUICK INSTALLATION GUIDE

I

ntelligent Remote Management Card allows a UPS 

system and environment sensor to be managed, 

monitored, and configured

K09-0000170-00

5. Connect the Ethernet cable 

to the Ethernet connector of 

the CyberPower Remote 

Management Card.

6. To connect with the 

environment sensor, use the 

RJ45 Ethernet cable. Plug 

one end into the Universal 

connector and the other end 

into the sensor.

7. Turn on the UPS.

4. Re-install and tighten the 

retaining screws.

3. Install the CyberPower Remote 

Management Card into the 

expansion port.

2. Remove the two retaining 

screws of the expansion port 

cover, then remove the cover.

1. Turn off the UPS before 

removing the expansion port 

cover on the UPS.

1. Install the Power Device Network Utility Tool from the included CD. It 

is located on the CD in the \tools\nework folder. Double click the 

“Power Device Network Utility” installation file, “Setup.msi” to begin 

the installation. 

2. After installation completes, run the “Power Device Network Utility” 

(Under “All Programs”, select “CyberPower Power Device Network 

Utility”.)

3. The main dialog of the Power Device Network Utility Tool program is 

shown in Figure. 1. The tool will display all Remote Management 

Cards present on the network. The "Refresh" button is used to search 

the entire local network again.

4. Select the Remote Management Card you are setting up. Click on the 

Tools menu and select “Device Setup” or double click the Remote 

Management Card you want to configure.

5. You can modify the IP Address, 

Subnet Mask, and Gateway 

address for the Device MAC 

Address listed in the Device 

Network Settings window, as 

shown in figure 2. The default IP 

Address is 192.168.20.177 and 

the default Subnet Mask is 

255.255.255.0.

6. Modify the IP, subnet mask 

or gateway address. Enter 

the new addresses into the 

corresponding fields.

Off

On(Yellow)

Off

On(Green)

Flash

The Remote Management Card is not 

connected to the Network or the Remote 

Management Card power is OFF

The Remote Management Card is connected 

to the Network

　

The Remote Management Card power is OFF

The Remote Management Card power is ON

- Receiving/transmitting data packet

- Reset finished

Figure 1. The main window of the “Power Device Network Utility” program.

Figure 2. The Device Network setting window.

LINK Indicator

RX/TX Indicator

Ethernt connector

Universal connector

RX/TX

Link

RMCARD303

Universal