Craftsman CM 14 INCH CHOP SAW Owner's Manual
2
3
2
3
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper
circuit protection. This tool is wired at the factory for 110-120 Volt operation.
It must be connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit
breaker. To avoid shock or fire, replace power cord immediately if it is worn,
cut or damaged in any way. Before using your tool, it is critical that you read
and understand these safety rules. Failure to follow these rules could result
in serious injury to you or damage to the tool.
PRODUCT SPECIFICATIONS
MOTOR
Type ...................................................................................... Universal
Amps ..................................................................................... 15
Maximum hp ......................................................................... 3.5
Voltage .................................................................................. 120
Hz ......................................................................................... 60
RPM (no load) ....................................................................... 3600
Cutting wheel arbor size ....................................................... 1 in.
Cutting wheel size ................................................................. 14 in.
Type ...................................................................................... Universal
Amps ..................................................................................... 15
Maximum hp ......................................................................... 3.5
Voltage .................................................................................. 120
Hz ......................................................................................... 60
RPM (no load) ....................................................................... 3600
Cutting wheel arbor size ....................................................... 1 in.
Cutting wheel size ................................................................. 14 in.
CUTTING CAPACITY
Cross cut 0°
Round ................................................................................ 5 in.
Square ............................................................................... 4-3/4 in. × 4-3/4 in.
Cross cut 0°
Round ................................................................................ 5 in.
Square ............................................................................... 4-3/4 in. × 4-3/4 in.
Rectangular ........................................................................ 3 in. × 8-1/4 in.
4-1/4 in. × 6-1/8 in.
4-1/2 in. × 5-1/8 in.
Miter cut 45°
Round ................................................................................ 4 in.
Square ............................................................................... 4 in. × 4 in.
Rectangular ........................................................................ 3-1/3 in. × 5 in.
Vise clamp angle ................................................................ 0° ~ 45
Round ................................................................................ 4 in.
Square ............................................................................... 4 in. × 4 in.
Rectangular ........................................................................ 3-1/3 in. × 5 in.
Vise clamp angle ................................................................ 0° ~ 45
°