Crane Merchandising Systems Hot Beverage Maker 6530006 User Manual
Hot Drink Center Set-Up Manual
18
6530006
March, 2001
2.
Mount the Base Plate:
WARNING
DO NOT MOVE THE CABINET WHILE HEX HEAD
SCREWS AND/OR CARRIAGE BOLTS ARE LOOS-
ENED. THE CABINET WOULD BECOME UNSTABLE
AND LIKELY TO TIP AND CAUSE INJURY.
SCREWS AND/OR CARRIAGE BOLTS ARE LOOS-
ENED. THE CABINET WOULD BECOME UNSTABLE
AND LIKELY TO TIP AND CAUSE INJURY.
a.
Remove the pail(s) from the inside of the merchandiser.
b.
Remove the floor liner from the inside of the merchandiser.
c.
Remove the two caps as shown.
d.
Loosen the left leg assembly carriage bolts and nuts to allow mounting a
base plate bracket.
base plate bracket.
e.
Secure one of the base plate brackets to the leg assembly using the two
carriage bolt. Tighten the carriage bolts and nuts.
carriage bolt. Tighten the carriage bolts and nuts.
f.
Loosen the right leg assembly hex head screws to allow mounting the
other base plate bracket.
other base plate bracket.
g.
Secure the other base plate bracket to the right leg assembly using the
two hex head screws. Tighten the hex head screws.
two hex head screws. Tighten the hex head screws.
h.
Insert the short arms of the slides into the hinged tabs of the base plate.
Position the slide so the notch near the short arm is on the bottom side.
Position the slide so the notch near the short arm is on the bottom side.
i.
Insert the long
arms of the
slides into the
base plate
brackets.
arms of the
slides into the
base plate
brackets.
j.
Insert and
secure a cotter
pin through
the hole in the
back of each
of the slides.
secure a cotter
pin through
the hole in the
back of each
of the slides.
k.
Push the base
plate toward
the merchan-
diser cabinet.
The front tabs of the base plate brackets should seat in the notches in the
long arms of the slides.
plate toward
the merchan-
diser cabinet.
The front tabs of the base plate brackets should seat in the notches in the
long arms of the slides.
l.
Replace the caps, liner, and pail(s) removed previously.
CAPS
BASE PLATE BRACKET
COTTER PIN
BASE PLATE
ASSEMBLY
SLIDE - L.H.
SLIDE - R.H.