Fujitsu Network Hardware V01 User Manual

94 

 

After the completion of the settings, click the 

 button.  The message below appears.  Click 

OK to apply the settings. * Reboot is not required. 

 

 

Recording operation 

Specify whether to perform 

recording operation upon start of the 

device. 

- Enable 

- Disable (Default) 

Recorder settings 

Recording mode 

Select the recording mode. 

- Record until full 

- Overwrite (Default) 

- Record until start position 

 
 

 

Recorded data is destroyed if the device power is turned off during recording.    Be  sure  to  stop 

recording before turning off the device power. 

 
If the device is started with an unused CF card inserted, the CF card is formatted unconditionally. 
If [Stream format] of Output interface settings (Main encoder ethernet) described in Section 3.3.1, 

"Setting (Encoder)," is "Standard TS," recording cannot be performed. 

 
The maximum system bit rate to record into CF card is limited up to 14.049 Mbps.  Recording to and 

reading from the CF card simultaneously is possible if the system bit rate does not exceed 6 Mbps. 

 
Recording and simultaneous streaming using the sub encoder are limited to cases in which [Video 

resolution] is "352 x 240," "352 x 288," "176 x 112," or "176 x 144" as described in Sub encoder settings 
(Encode) in Section 3.3.1, "Setting (Encoder)."