Contax i4R User Manual
EN-25
Getting Ready
Inserting the Battery Pack
1
Releasing the latch on the card/battery
cover.
q
Use the pad of your finger to slide the card/battery cover in the
direction of the arrow until there is a click and the latch is released
(approximately 1 mm).
direction of the arrow until there is a click and the latch is released
(approximately 1 mm).
w
The bottom part of the card/battery cover opens (approximately
10 mm).
10 mm).
2
Open the card/battery cover.
e
Pull out the card/battery cover until it is stopped by the hinge.
r
Fully open the card/battery cover.
3
Insert the battery pack (BP-760S)
supplied with the camera.
Turn the battery stopper at the end of the battery pack in the direction of
the arrow while inserting the battery pack, as shown in the illustration.
the arrow while inserting the battery pack, as shown in the illustration.
4
Close the card/battery cover.
Push the card/battery cover into the opening in the camera surface
while you close it, then slide it in the direction of the arrow until it clicks
and locks.
Make sure the hinge does not lift up as you close the cover.
while you close it, then slide it in the direction of the arrow until it clicks
and locks.
Make sure the hinge does not lift up as you close the cover.
A
Important
• Insert the battery pack until the battery stopper
is securely locked (returns to its original
position).
position).
• Be sure to insert the battery pack in the correct
direction, as inserting the battery pack the
wrong way around may cause damage.
wrong way around may cause damage.
2
1
4
3
Hinge
Battery
Pack
Pack
Battery Pack Slot
Battery Stopper
A
and B signs
Push against
the upper
surface.
the upper
surface.