Contax i4R User Manual

Inserting the Memory Card

1

Check that the camera is switched off 

and then release the card/battery cover 

latch.

q

Use the pad of your finger to slide the card/battery cover in the 
direction of the arrow until there is a click and the latch is released 
(approximately 1 mm).

w

The bottom part of the card/battery cover opens (approximately 
10 mm).

2

Open the card/battery cover.

e

Pull out the card/battery cover until it is stopped by the hinge.

r

Fully open the card/battery cover.

3

Insert the memory card.

Insert the memory card with the labeled side facing the lens side of the 
camera.
When inserting the card, push it into the slot until it makes a clicking 
sound and stops.

4

Close the card/battery cover.

Push the card/battery cover into the opening in the camera surface 
while you close it, then slide it in the direction of the arrow until it clicks 
and locks.
Make sure the hinge does not lift up as you close the cover.

A

Important

• If the card does not slide in smoothly, the card may be upside down. Check that the 

card is the right way up and do not try to force it into the slot.

• Do not attach stickers of any sort to the memory card as this may jam the card in 

the slot so that you cannot remove it.

B

Note

Format the memory card in the camera before shooting to ensure the best possible 
performance from the camera. (Æ p.161)

Hinge

Memory 
Card Slot

Labeled 
Surface

Cutout 
Section

Push against 
the upper 
surface.