Frymaster CT16 Series User Manual

1-3

Step 10d - Remove last two screws

and pull conveyor away from housing.

Step 10c - Remove

these four hex head

screws and two nuts.

Step 10b - Remove

cartridge heater.

Step 10a - Remove drive pulley.

11. To remove the toasting conveyor assembly:

(See illustration on following page.)

a.  Detach the platen and probe wiring from the relay, high-limit, and 9-pin connector.

b.  Loosen the setscrew in the second drive pulley from the front and remove the pulley.

c.  Remove the five flange nuts that secure the idler assembly to the housing and remove the idler

assembly.

d.  Remove the two hex head screws shown in Step 11d of the illustration on the following page.