Manualsbrain.com
  1. Manuals
  2. Brands
  3. Fostex
  4. PD606
  5. User Manual

Fostex PD606 User Manual

Download
Page of 226
186
Location Recorder  Model PD606
Chapter 8: MENU mode/TC SETUP menu
You can set the time code user bit and user bit mode of the time code which is output from the
[TIME CODE OUTPUT] connector when the "Sel TC Out" item is set to "Gen".
User bit setting [Set Gen Ubit]
• Jamming the time code value in Free run mode:
If you press the [TIME] key while the editing screen (the "Set Gen TC" screen where an
editing point is flashing) is shown, the LTC start time is jammed to the internal realtime
clock data.
3)
Press the [EXIT] key repeatedly until you exit the MENU mode.
Sets the user bit mode. See the
table below for details about the
available options. The default is
“uuuuuuuu”, which is set to “00 00
00 00” by default.
Shows the user bit being output
according to the current user bit
mode. If you change the user bit
mode.
Selecting the user bit mode
By pressing the [ENTER/YES] key while “Ubit MD: uuuuuuuu” is highlighted, the current
user bit mode starts flashing and you can now select the mode (by default, “uuuuuuuu”
flashes).
Shows the current
user bit. You can set
the desired user bit.
The rightmost two
figures of the user bit
are always used re-
gardless of the “Ubit
MD” setting.
Flashing
2)
Use the [MENU] dial to select the “Set Gen Ubit” menu item, and press the [ENTER/YES] key.
The display now shows the “Set Gen Ubit” screen on which you can set the user bit mode
and the user bit value.
1)
When the unit is stopped, press the [SHIFT] key to light the [SHIFT] indicator, followed by the
[TIME/TC SET] key.
The display now shows the TC SETUP menu screen.