Fostex PD606 User Manual
83
Location Recorder Model PD606
Chapter 5: Recording/Playback
Using the [SEND LEVEL] control on each of channels 1 through 6, you can adjust the signal
level sent to the stereo bus. Using the [ST BUS MASTER] control, you can adjust the stereo bus
master level.
level sent to the stereo bus. Using the [ST BUS MASTER] control, you can adjust the stereo bus
master level.
Controlling signals sent to the stereo bus
[SEND LEVEL] controls
[ST BUS MASTER] control
When the READY indicator in the stereo bus master section flashes, you are ready to record
the stereo bus signals or digital input 7/8 (depending on the setting of the "Rec source sel"
item) to the stereo tracks (see pages 91 and 146).
the stereo bus signals or digital input 7/8 (depending on the setting of the "Rec source sel"
item) to the stereo tracks (see pages 91 and 146).
[PAN] keys
Using the [PAN] key on each of channels 1 through 6, you can select "L", "C" or "R" for the
panning position of the channel signal sent to the stereo bus. Each time you press the [PAN]
key, the option ("C", "R", "OFF" or "L") changes, and the corresponding indicator lights.
When "Off" is selected, no indicator is lit and the channel signal is not sent to the stereo bus.
panning position of the channel signal sent to the stereo bus. Each time you press the [PAN]
key, the option ("C", "R", "OFF" or "L") changes, and the corresponding indicator lights.
When "Off" is selected, no indicator is lit and the channel signal is not sent to the stereo bus.
<Note>:
By default, each [SEND LEVEL] control affects the level of the corresponding input
signal sent to the stereo bus. However, by setting the "Disk Feed" item in the "SYS SETUP" menu
of the MENU mode to "Post", it also affects the level of the signal sent to the corresponding
track as well as the level of the signal sent to the stereo bus (see page 169).
of the MENU mode to "Post", it also affects the level of the signal sent to the corresponding
track as well as the level of the signal sent to the stereo bus (see page 169).
[PFL/SEL] key
You can reverse the phase of the input signal by pressing the [SHIFT] key followed by the
[PFL/SEL] key of the desired channel. The [REV.] indicator under the bargraph meter of a
phase-reversed channel is lit. To disable the phase reverse, press the [SHIFT] key followed by
the [PFL/SEL] key again.
[PFL/SEL] key of the desired channel. The [REV.] indicator under the bargraph meter of a
phase-reversed channel is lit. To disable the phase reverse, press the [SHIFT] key followed by
the [PFL/SEL] key again.
Phase setting (for channels 1 through 6)
SHIFT
[REV.] indicator
L
C
R
OFF
light in green
light in yellow
unlit
unlit
unlit
unlit
unlit
unlit
unlit
light in yellow
light in yellow light in green