Fluke Car Amplifier 5220A User Manual
2-1
Section 2
Operating Instructions
2-1. Introduction
This section of the manual contains information concerning the installation and operation
of the Model 5220A transconductance Amplifier. It is recommended that the contents of
this section be read and understood before any attempt is made to operate the unit. Should
any difficulties arise during operation, contact your nearest John Fluke Sales
representative, or the John Fluke Mfg. Co., Inc., P.O. Box C9090, Everett, WA 98206;
telephone (206) 347-6100.
of the Model 5220A transconductance Amplifier. It is recommended that the contents of
this section be read and understood before any attempt is made to operate the unit. Should
any difficulties arise during operation, contact your nearest John Fluke Sales
representative, or the John Fluke Mfg. Co., Inc., P.O. Box C9090, Everett, WA 98206;
telephone (206) 347-6100.
2-2. Shipping Information
The 5220A is packaged and shipped in a foam-packed container. Upon receipt of the
instrument, a thorough inspection should be made to reveal any possible shipping
damage. Special instructions for inspection and claims are included on the shipping
carton.
instrument, a thorough inspection should be made to reveal any possible shipping
damage. Special instructions for inspection and claims are included on the shipping
carton.
If reshipment of the instrument is necessary, the original container should be used. If the
original container is not available, a new container can be obtained from the John Fluke
Mfg. Co., Inc. Please reference the instrument’s model number when requesting a new
shipping container.
original container is not available, a new container can be obtained from the John Fluke
Mfg. Co., Inc. Please reference the instrument’s model number when requesting a new
shipping container.
2-3. Input Power
The 5220A can be operated from any one of the following 50 to 60 Hz (
±
1 %) line
voltages: 100, 110, 115, 120, 200, 220, 230, or 240 V ac (
±
10 %). A rear panel decal
specifies the voltage selected prior to shipment. If a change in voltage is required, refer to
Section 4 of this manual for the selection procedure.
Section 4 of this manual for the selection procedure.