FireplaceXtrordinair 36 DV EFIII User Manual

4040708

A 1/2" clearance is required along the sides and back of the fireplace. The 1/2" stand-offs on the sides
and 6-1/4" stand-offs on the top of the fireplace are designed to separate the fireplace from the
framing members.  These stand-offs may contact the framing members but no material may be placed
between the stand-offs.

AAAA

AAAA

AAAA

A

A

AAAA

AAAA

AAAA

AA

AA

AA

AA

AA

AA

AA

AA

AA

AA

AA

AA

A

AA

AA

A

Gas line (3/8" M.P.T. or 1/2" F.P.T.) 
should be routed 6-5/8" behind the 
framing opening and 1-7/8" above 
the base of the fireplace (see "Gas 
Line Connection" for details).

43-1/4"

19-5/8"

46-1/2"

Route the electrical line to a position 
at the right rear of the fireplace.

If using a remote control or 
thermostat, route the wire to a 
location near the gas line (include 
an extra 3' length for hookup).

NOTE: if venting directly to the rear, 
make sure there is a min. 8-5/8" space 
centered behind the fireplace for the 
wall thimble.  If a 90° elbow is used 
directly off of the fireplace, the thimble 
will be centered 51-1/4" above the 
base of the fireplace.

NOTE:  If using the power heat vent, 
allow for the duct passage when 
framing the enclosure.

Fireplace must be installed on a level surface capable of supporting the fireplace and vent

Fireplace must be placed directly on wood or non-combustible surface (not on linoleum or carpet)

Due to the high temperature of the fireplace, it should be located out of traffic and away from furniture
and draperies.

This heater may be placed in a bedroom.  Please be aware of the large amount of heat this appliance
produces when determining a location.

When installed, walls in front of the fireplace must be a minimum 4-1/2" to the side of the faceplate.

Fireplace must be placed so that no combustibles are within, or can swing within 36" of the front of the
fireplace (e.g. drapes, doors)

Fireplace must be placed so the vents below and above the glass do not become blocked