FIC M295 User Manual

 

Installation and Upgrade 

4.  Locate the memory module socket. Align the notch with the notch in the socket connector 

and insert the module as follows: 

−  Hold the SODIMM at a 60-degree angle and align the SODIMM connector with 

the socket in the system. Push the connector into the socket. 

−  Press down on the edge of the SODIMM until the locking tabs on the sides snap 

into place, securing the module. 

 

 

 

 

5.  To remove a SODIMM, press the locking tabs away from the sides of the module until 

the module pops up. Then, remove the SODIMM. 

 
6.  Reassemble the notebook components as follows. 

−  Put the DIMM door back. 

−  Replace the screw and turn the system over. 

 

2.3.7  Removing the Internal Hard Disk Drive 

The notebook provides a built-in hard disk for the primary IDE controller. The HDD is an 
industry standard 2.5” IDE disk drive with a maximum height of 9.5mm, and can be upgraded 
with another standard 2.5” HDD with a maximum height of 9.5mm. 
 
1.  Find out the built-in hard disk secured with one screw at the upper right corner of the hard 

disk. Remove this screw and carefully pull the hard disk module from the connector. 

 

 

 

 

FIC M295/M296 Service Manual 2-13