Chrysler K6860631 User Manual
1
WI-FI ROUTER
JEEP COMMANDER
PROCEDURE STEPS:
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two
minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is
the only sure way to disable the airbag system. Failure to these instructions may result in possible serious or
fatal injury.
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two
minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is
the only sure way to disable the airbag system. Failure to these instructions may result in possible serious or
fatal injury.
NOTE: Using a test light, verify the cigarette lighter outlet being used is ignition switched. Power must not be
supplied with the ignition in the OFF position.
supplied with the ignition in the OFF position.
1.
Place the shifter to the most rearward position and set
the parking brake.
the parking brake.
2.
Place the passenger seat to the full forward position.
3.
Remove the seat belt anchor cover (1).
4.
Remove the seat belt anchor bolt.
5.
Remove the passenger seat rear floor mounting bolts
(2).
(2).
6.
Place the passenger seat to the full rearward position.
7.
Disconnect and isolate the battery negative cable.
8.
Remove the passenger seat front floor mounting bolts
(4).
(4).
9.
Disconnect the passenger seat electrical connector
(3) and remove the seat from the vehicle.
(3) and remove the seat from the vehicle.
10. Remove the front passenger door scuff plate (1).
Aug 08, 2008
K6860631 Rev. 1
INDEX
PRINT THIS VEHICLE