Casio CasioIsa 550 With Wifi 3y Security ISA550WBUN3K9 User Manual

Using the Setup Wizard for the Initial Configuration

Cisco ISA500 Series Integrated Security Appliances Administration Guide

39

 

Use the License Installation page to validate the security license, which is used to 
activate security services on the device. 

If the security license is already installed on the security appliance, click Next to 
proceed next step. 

If the security license is not installed on the security appliance, enter the following 
information to validate the security license: 

•

Email Address: Enter the registered email address to receive the PAK ID.

•

PAK ID: Enter your Product Authorization Key in this field. You can find the 
license code from the Software License Claim Certificate that Cisco 
provides upon purchase of the security appliance.

NOTE: A valid Cisco.com account is required to validate the security license. 
If your Cisco.com account credentials are not configured, go back to the 
Cisco.com Credentials page to configure them. 

NOTE: If you want to continue the Setup Wizard configuration without installing the 
security license, check the box next to Continue without installing license (not 
recommended). The security services cannot be activated without installing the 
security license. 

After you are finished, click Next. 

Use the Discovery page to enable Bonjour and/or CDP discovery protocols on the 
security appliance. For optimal device discovery and topology support via the 
OnPlus portal, enable both discovery protocols.

•

Enable Bonjour Discovery Protocol: Check this box to enable Bonjour 
discovery protocol, or uncheck this box to disable it. 

•

Enable Cisco Discovery Protocol (CDP): Check this box to enable Cisco 
Discovery Protocol (CDP), or uncheck this box to disable it. 

NOTE: Discovery protocols are only operational on the LAN ports of the 
security appliance. 

After you are finished, click Next.