Cabletron Systems EMM-E6 User Manual

 

Controls and Indicators

 

The recessed reset switch re-initializes the EMM-E6 processor. The 
activation of this switch will not initialize Non-Volatile Random Access 
Memory (NVRAM) where the EMM-E6 stores configuration and 
management parameters. The reset switch may be pressed with the point 
of a pencil or pen. Once pushed in, the EMM-E6 will re-initialize itself.

 

The EMM-E6 incorporates the LANVIEW status monitoring and 
diagnostic system. LANVIEW LEDs can help diagnose many problems, 
such as a fault in network cabling. LANVIEW LEDs are identified in 
Section 2.3, 

 

.

 

The EPIM slot is a covered opening in the EMM-E6 faceplate that can be 
configured with an optional EPIM module.

 

The EMM-E6 faceplate provides two serial communications ports for the 
connection of out-of-band management devices.

 

The BRIM slot is a covered opening in the faceplate that can be 
configured with a BRIM module.

 

The components listed in the following entries are all hidden inside the 
MMAC chassis when the EMM-E6 has been installed. These components 
may be located by removing the EMM-E6 from the chassis and holding 
the module in the orientation shown in Figure 2-2 and Figure 2-3.

 

ICH1Book  Page 2  Tuesday, August 6, 1996  3:06 PM