Avital 5103 Owner's Manual

➢

Disarming without a transmitter

If your transmitter is lost or damaged, you can manually disarm your vehicle

security system. To disarm the system without a transmitter, you must have the

vehicle’s ignition key and know where the Valet

switch is located. Be sure to

check with your installer at the time of installation for both the location and the

preset response (1-5 presses) of the Valet

switch. The factory default setting is

1 press.

To disarm the security system, turn the ignition to the ON position.

Press and release the Valet button the preset number of times (one to five times)

within 15 seconds. After five seconds, the sys tem will disarm. If the system does

not disarm, you may have waited too long; turn the ignition off and on, and

then try again.

DRW-35

Location of Valet Button_________________________________

Number of Presses_____________________________________

Important: The Valet button can be programmed to re-

spond to 1-5 presses for the disarm function. You must

check with the installer to verify the programming for your

individual unit

➢

Silent mode

To temporarily turn off the arm or disarm chirps, use Silent Mode™. Press

for less than one second before arming or disarming, and the confirmation

chirp(s) will be eliminated for that one op er a tion only. If you want the arm/

disarm chirps turned off permanently, your dealer can do this for you. The Warn

Away® response to lighter impacts is bypassed if the system is armed using

Silent Mode. This ensures that no chirps will be emitted by the siren in an area

you want chirp-free. The system is still fully capable of triggering. Only the Warn

Away® response is bypassed.