Avocent Access Router Cyclades-PR1000 User Manual
Cyclades-PR1000
27
Chapter 4 - Step-by-Step Instructions
STEP THREE
The network protocol parameters, shown in Figure 4.4, are similar to those for the Ethernet interface. Fill in the
parameters for your network in the right-most column.
The network protocol parameters, shown in Figure 4.4, are similar to those for the Ethernet interface. Fill in the
parameters for your network in the right-most column.
Menu CONFIG=>INTERFACE=>SWAN=>NETWORK PROTOCOL=>IP
Parameter
Parameter
Example
Your Application
Active or Inactive
Active enables IP communication (IPX and
Transparent Bridge are not used in this
example).
Transparent Bridge are not used in this
example).
Interface Unnumbered/
Numbered
Numbered
Numbered
Primary IP Address
0.0.0.0 (This number will be assigned by the
Access Provider dynamically.)
Access Provider dynamically.)
Subnet Mask
255.0.0.0
Secondary IP Address
0.0.0.0 for none
IP MTU
Use the preset value, 1500. This determines
whether or not a given IP datagram is
fragmented.
whether or not a given IP datagram is
fragmented.
NAT
Global Assigned because the IP address of
the SWAN interface will be assigned
dynamically.
the SWAN interface will be assigned
dynamically.
Enable Dynamic Local IP
Address
Address
Yes, because the IP address of the SWAN
interface will be assigned dynamically.
interface will be assigned dynamically.
Remote IP Address Type
Any
Remote IP Address
0.0.0.0
ICMP Port
Inactive
Incoming Rule List Name
None, filters are not included in this example.
Outgoing Rule List Name
None, filters are not included in this example.
Routing of Broadcast
Messages
Messages
Inactive
FIGURE 4.4 SWAN NETWORK PROTOCOL (IP) MENU PARAMETERS