AVerMedia Technologies AVERDIGI EB5416DVD User Manual

Alarm Out Time

Set the amount of time (in second) to continue sending the alarm once activated

(3) Sensor Setup

Sensor Status

Customize the initial state of the attached sensor for every camera. Refer to the table below

to customize the sensor state.

Not installed: Indicates that there is no sensor connected

Normal open: Indicates that the initial state of the sensor is normal open. Video

recording initiate when there is a changes in the sensor state

Normal close: Indicates that the initial state of the sensor is normal close. Video

recording initiate when there is a changes in the sensor state

Sensor Record Time

Set the amount of time (in second) to record after the sensor has been triggered

(4) Spot Monitor
To display channel alarm event in full screen mode when the sensor is activated or motion is

detected. When there are multiple alarm events, DVR system will display the last alarm event.

Sensor

Select the channel that will send out the alarm event for display when the sensor has been

triggered.

Motion

Select the channel that will send out the alarm event for display when the motion has been

detected.

Camera

Select the channel to display alarm event.

Call Monitor Time

Set a period time (0 ~ 255 sec) for alarm event to display on surveillance screen.