Avaya Media Gateway G700 User Manual

 describes a few Command Line Interface commands that you will need to navigate 

among the processors on the G700.

Note:

This navigational aid assumes that you are logged in to the P330 Stack 
Processor. Default mode is Supervisor with a P330-1(super)# command-line 
prompt.

The command-line prompts in an MGP session use the media gateway name that is assigned 
when the gateway is configured.

You can telnet to another processor from a current telnet session.

change to supervisor 
mode

P330-y(super)#
or <MG-xxx>-y(super)#
where xxx is the media gateway 
number assigned on the add 
media-gateway form, and y is the 
"module number" of the G700 in the 
stack. 

change to 
configuration mode

P330-1(configure)#
or <MG-001>-1(configure)#

 

mgp
(from a stack processor 
session)

open a CLI session on 
the mgp processor

 

stack
(from an MGP session)

open a CLI session on 
the stack processor

session icc
(from an MGP session)

open a CLI session on 
the S8300 processor

open a session on the 
stack processor in 
module (i.e. another 
G700)<#> in the stack 

 

close the current 
session (and revert to 
the previous session)

displays help for 
<command>