Avaya Bogen Telephone Paging Amplifier 35- and 100-Watt Models Installation Instruction

Page of 12
Introduction
This document describes the Lucent 35- and 
1
00-watt Telephone Paging Amplifiers.
These are full-featured, wall-mounted amplifiers which provide inputs for dry loop
600-ohm telephone page signal, background music source, and low impedance
microphone. A set of control inputs allow an external contact closure to mute
background music and open the telephone page channel. Background music mute
level during page is adjustable and the music slowly fades back in after the page is
completed.
An automatic level control system limits the output level of the
telephone page channel so that differences in the volume of the paging party's voice
will be less noticeable. Bass and treble controls are provided for adjusting the quality
of the output signal. An Aphex
®
Aural Exciter feature is also provided. Aphex
improves the clarity of the output signal by replacing the higher frequency harmonics
that are normally lost through the telephone system. This amplifier includes a built-
in night ringer that can be triggered by either a standard telephone (analog) ring
signal or an external contact closure. The night ringer mutes the background music,
but not pages.
Package Contents
* Telephone Paging Amplifier unit
* Pair of Rack Mount Brackets
* 8 mounting screws
* Installation and Use Manual
Before You Start
Review the contents of the box. Read through this entire manual to understand how
this product installs and operates.
NOTE: Be sure you have enough 22 AWG shielded, twisted pair wire (COM Code:
40
1
882956, PEC Code: 2734-SPK) for your speaker runs.
Telephone Paging Amplifier
Page 4 of 
1
2
PEAK LEVEL
POWER
 AMPLIFIER
ALC
TEL VOLUME
MIC VOLUME
MUSIC VOLUME
MUSIC MUTE
RINGER VOLUME
BASS
TREBLE
APHEX
RING
TEL
TEL
BAL
MIC
GND
RING
CONTACT
+
BAL
T
R
TEL
MIC
COM
CONTROLS
MUSIC IN
BRIDGING
Figure 1: Telephone Paging Amplifier