Auralex Acoustics Elite Pro System EPS-112T User Manual
Recommended Additional Installation Materials
• Power Drill
• Tape measure
• Carpenters Level
• Small ladder (depending on ceiling height)
• Pencil
• 16 2.5” 4D finish nails
• Straight Edge
• 160 .75”-1” drywall screws
• Nail Set
• Hammer
Elite Pro System EPS-112T General Information
B22 ProPanel Installation Guide
➋
Install four impaling clips within marked
B22
ProPanel location using drywall screws. Exact
placement of each clip is not necessary.
➊
Mark intended location of each
B22
ProPanel on the wall or ceiling.
Marked panel
outline
outline
➌
Start the
B22 ProPanel 5/8” above its intended
final height and press downward at a 45° angle
until the panel is flush with the wall or ceiling
surface.
until the panel is flush with the wall or ceiling
surface.
TIP
For permanent mounting, apply Tubetak Pro
adhesive to the back of the B22 ProPanel
before completing Step 3.
adhesive to the back of the B22 ProPanel
before completing Step 3.
CAUTION
Always use Tubetak Pro on the back of the
panel when attaching it to the ceiling.
panel when attaching it to the ceiling.