Ariens 946101-ST622 User Manual

Page of 20
GB - 6
This product is equipped with an internal 
combustion engine. DO NOT use on or near 
any unimproved, forest or brush covered land 
unless the exhaust system is equipped with a 
spark arrestor meeting applicable local, state 
or federal laws. A spark arrestor, if used, must 
be maintained in effective working order by the 
operator. See your Ariens Dealer or engine 
manufacturer’s service center.
Fuel is highly flammable and its vapors can 
explode. ONLY use approved fuel containers.
NO Smoking!
NO Sparks!
NO Flames!
Allow engine to cool before filling fuel 
tank. 
Never fill containers inside a vehicle or on a 
truck or trailer bed with a plastic liner. Always 
place containers on the ground away from 
your vehicle before filling.
When practical, remove gas-powered 
equipment from the truck or trailer and refuel it 
on the ground. If this is not possible, then 
refuel such equipment on a trailer with a 
portable container, rather than from a gasoline 
dispenser nozzle.
Keep the nozzle in contact with the rim of the 
fuel tank or container opening at all times until 
fueling is complete. Do not use a nozzle lock-
open device.
Check fuel supply before starting engine.
DO NOT fill gasoline tank indoors, when 
engine is running, or while engine is hot.
Allow engine to cool several minutes before 
removing fuel cap.
DO NOT overfill. Allow about 1/4" (6 mm) of 
tank space for fuel expansion.
Replace gasoline tank cap securely and clean 
any spilled fuel before starting engine. 
If fuel is spilled on clothing, change clothing 
immediately.
NEVER store fuel inside where there is an 
open flame, such as a water heater.
ALWAYS drain fuel outdoors away from 
ignition sources.
Avoid Electric Shock. DO NOT disconnect 
wire from spark plug while engine is running. 
Accidental engine start up can cause death or 
serious injury. Except where specifically 
recommended, ALWAYS stop engine, wait for 
moving parts to stop, allow parts to cool and 
disconnect spark plug wire before inspecting, 
servicing, adjusting or repairing unit.
Keep unit free of grass, leaves, or other debris 
build-up.
Keep equipment in good condition.
Maintain or replace safety and instruction 
labels, as necessary.
Follow engine manufacturer’s safety 
instructions when servicing engine.
Check all hardware at regular intervals, 
especially trimmer head attachment bolts. 
Keep all hardware properly tightened.
Before tipping unit, remove fuel.
DO NOT tip the trimmer up or over unless 
specifically instructed to do so.
Ensure all wheel blocks, jack stands and tie 
downs will support unit during maintenance.
Replace worn-out mufflers immediately. 
Continued use could result in fire or explosion.
Sharp edges can cut or amputate fingers or a 
hand. Wrap blade or wear sturdy gloves to 
service.
Use only replacement parts designed for your 
unit. See your Ariens Dealer.
Allow engine to cool before storing in any 
enclosure.
ALWAYS clean unit before extended storage. 
See engine manual for proper storage.
DO NOT store unit inside a building with fuel in 
the fuel tank where any ignition sources are 
present.
Use only accessories which have been 
approved by Ariens and are properly installed.
Check attachments frequently and replace 
worn or damaged components with 
manufacturer’s recommended parts.