Anritsu ML2430A User Manual
Chapter 3
Connections
3-1
INTRODUCTION
This chapter describes physical connections to the power meter on both
the front and rear panels.
the front and rear panels.
3-2
FRONT PANEL
CONNECTORS
CONNECTORS
The front panel connectors are illustrated in Figure 3-1. Detailed descrip-
tions of each connector follow.
tions of each connector follow.
Calibrator
0.0 dBm Reference
This connector is a precision female N-Type, 50 Ohm connector that provides a
precision, traceable 0.0 dBm, 50 MHz reference signal for absolute calibration of
the sensors. The calibration signal can be turned on or off through the
precision, traceable 0.0 dBm, 50 MHz reference signal for absolute calibration of
the sensors. The calibration signal can be turned on or off through the
Cal/Zero
menus (see Chapter 4, Front Panel Operation). Use only compatible 50 Ohm N-
Type connectors.
Type connectors.
ML2430A OM
3-1
Figure 3-1. Model ML2430A Series Power Meter Front Panel Connectors
Calibrator
Connector
Connector
Sensor A
Connector
Connector
Sensor B
Connector
Connector
(ML2438A only)