American Standard ALTO 70145A 11/00 User Manual

WARNING:

To transport the machine, follow this procedure:

1. Make sure the power cable is disconnected from

the electrical outlet.

2. Disconnect the handle pigtail cord connection.

(twist and pull)  See figure #3.

3. Loosen the belt tension T-screw completely.

Grasp the belt guard immediately above the left-
hand truck wheel.  Pull to gain access to the drive
belts.

4. Grasp and pull the belt guard to gain entry to drive

belts.  Remove the drive belts.  See figure #4.

5. Screw the motor mounting knob clear of the

counterbore on chassis.  See figure #5.

6. Straddle the machine.  With your legs, lift the

motor off of the chassis.  Take the motor to
worksite.

7. Lift the chassis by grasping the front handle and

rear of chassis. Bring the belt guard against your
chest.  Take the chassis to worksite.

To assemble the machine after transporting, follow
this procedure:

1. Place the motor on the chassis.  Position the

strap on the threaded end of the rear motor mount
against the boss on the chassis.

2. Screw in the motor mounting knob completely.

3. Install the drive belts.

4. Tighten the belt tension T-screw until the contact

drive wheel belt experiences a ½" deflection at
mid-span when 10 lbs. of effort is exerted upon it
with a thumb.

Figure 3

Figure 4

Figure 5