AMC SCD23/D24 User Manual
ENGLISH
Notes and Safety Instructions
10
10
Precautions regarding the Lithium battery
1. The lithium battery maintains the clock function and user settings; even if the battery pack or AC adapter is removed.
2. The lithium battery for the camcorder lasts about 6 months under normal operation from time of installation.
3. When the lithium battery becomes weak or dead, the date/time indicator will flash for about five seconds
2. The lithium battery for the camcorder lasts about 6 months under normal operation from time of installation.
3. When the lithium battery becomes weak or dead, the date/time indicator will flash for about five seconds
when you set the power switch to CAMERA.
In this case, replace the lithium battery with a new one (type CR2025 ).
In this case, replace the lithium battery with a new one (type CR2025 ).
4. Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Warning: Keep the LITHIUM BATTERY out of reach of children. Should a battery be swallowed,
consult a doctor immediately.
Danger:
- The Video Light can become extremely hot. Do not touch it during operation or after turning it off,
otherwise serious injury may result. Wait 5 minutes (approx.) for the light to cool down.
- Do not place the camcorder into the carrying case immediately after using the video light.
The video light will be hot.
Please allow time for it to cool down.
Please allow time for it to cool down.
- Do not use it near flammable or explosive materials.
- It is recommended that you consult your nearest SAMSUNG dealer for replacement bulbs.
- Not to be handled by children. Emits intense heat and light.
- It is recommended that you consult your nearest SAMSUNG dealer for replacement bulbs.
- Not to be handled by children. Emits intense heat and light.
Use with caution to reduce the risk of fire or injury to persons.
DANGER: DO NOT DIRECT LIGHT AT PERSONS OR MATERIALS LOCATING LESS THAN FOUR FEET DURING USE.
DISCONNECT WHEN NOT IN USE.
DANGER: TO PREVENT POSSIBLE BURN HAZARD, DISCONNECT THE SUPPLY CORD AND ALLOW THE LAMP TO
COOL DOWN BEFORE REPLACING.
Notice regarding VIDEO LIGHT
00616B SCD23-SEA(01~27) 5/12/03 9:46 AM Page 10