AMANO HandPunch 1000 Installation Instruction

HandPunch 1000 Installation and Operation Manual

Page 46

Revision 1.2

Various messages can appear on the HandPunch’s display during hand verification. 
These messages are defined in Table 8.

•

If the display shows TRY AGAIN, you are not verified. You may have made an 
error in entering your ID number or in placing your hand on the platen. Re-enter 
your ID number and try again, taking care to follow proper hand placement rules 
(see page 44).

•

If the display shows TIME RESTRICTION, you are not authorized to punch in 
at this time. If this seems to be in error, contact your supervisor about time 
restrictions.

•

After a pre-programmed number of denied attempts, an ID number will no longer 
be accepted and the display will appear as follows.

This is called a “lockout.” Before the rejected ID number can be used again, 
another employee or a supervisor must successfully verify at the HandPunch.

Message

Definition

PLACE HAND

The platen is ready to receive your hand for verification.

ID VERIFIED

You are verified, proceed.

REMOVE HAND

Remove your hand and place it on the platen again. Follow 
proper hand placement rules.

TRY AGAIN

Your attempt was rejected. Repeat verification following 
proper hand placement rules.

ID REFUSED

Your rejections exceeded the maximum number of tries 
allowed. Wait until another employee has verified and try 
again or call your supervisor.

ENTER ID

You entered your ID number incorrectly or your access time 
is restricted.