Alpine CDA 105 - 200 Watt AM/FM/MP3 iPod Receiver Owner's Manual
41
-EN
Installation
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
mounting sleeve.
3. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
• Secure the ground lead of the unit to a clean metal spot using a
screw (*
3
) already attached to the vehicle’s chassis.
iPhone/iPod Connection (sold separately)
Connect USB cable to an iPhone/iPod with Interface cable for
iPod (KCU-440i, sold separately).
iPod (KCU-440i, sold separately).
Caution
When you install this unit in your car, do not remove the
detachable front panel.
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
might press too hard and warp the metal plate that holds it in
place.
1
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
Remove the mounting sleeve from the main unit
(see “Removal” on page 41).
(see “Removal” on page 41).
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
1
) already
attached to the vehicle’s chassis.
• For the screw marked “*
2
”, use an appropriate screw for the chosen
mounting location.
Detachable Front
Panel
Panel
Less than 35°
Mounting Sleeve
(Included)
(Included)
Dashboard
This unit
Pressure Plates*
Hex Nut (M5)
Screw
Bolt Stud
This unit
Chassis
Ground Lead
Metal
Mounting
Strap
Mounting
Strap
*
2
*
1
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the CDA-105. Connect all other
leads of the CDA-105 according to details described
in the CONNECTlONS section.
equalizer to the corresponding output lead coming
from the left rear of the CDA-105. Connect all other
leads of the CDA-105 according to details described
in the CONNECTlONS section.
3
Slide the CDA-105 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
This unit
Bracket keys
(Included)
(Included)
Front Frame
Screws (M5 × 8)
(Included)
(Included)
Mounting Bracket
Ground Lead
This unit
*
3
Interface cable for iPod (KCU-440i, sold separately)
USB cable