Aiwa AM-NX1 User Manual
32
•
Though the battery charging stand and the
battery may become hot during the charging
procedure, this poses no danger.
battery may become hot during the charging
procedure, this poses no danger.
•
If you charge the battery for the first time or
after a long period of disuse, the battery may
not charge up to its rated capacity. This is a
normal characteristic. After you use and
recharge the battery a few times, it will return
to its normal charge capacity.
after a long period of disuse, the battery may
not charge up to its rated capacity. This is a
normal characteristic. After you use and
recharge the battery a few times, it will return
to its normal charge capacity.
•
If the capacity of the rechargeable battery
drops to half the normal amount, replace with
the new one.
drops to half the normal amount, replace with
the new one.
On the dry battery case
The supplied dry battery case is designated for
this recorder only.
this recorder only.
On the MiniDisc cartridge
•
When carrying or storing the MiniDisc, keep
it in its case.
it in its case.
•
Do not break open the shutter.
•
Do not place the cartridge where it will be
subject to light, extreme temperatures,
moisture or dust.
subject to light, extreme temperatures,
moisture or dust.
•
Attach the supplied MD label only in the
space designated for it on the disc. Do not
stick it on any other disc surface.
space designated for it on the disc. Do not
stick it on any other disc surface.
On cleaning
•
Clean the recorder casing with a soft cloth
slightly moistened with water or a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent such
as alcohol or benzene as it may mar the finish
of the casing.
slightly moistened with water or a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent such
as alcohol or benzene as it may mar the finish
of the casing.
•
Wipe the disc cartridge with a dry cloth to
remove dirt.
remove dirt.
•
Dust on the lens may prevent the unit from
operating properly. Be sure to close the disc
compartment lid after inserting or ejecting an
MD.
operating properly. Be sure to close the disc
compartment lid after inserting or ejecting an
MD.
•
To obtain the best sound quality, use a dry
cloth to wipe the plugs of the headphones/
earphones or the remote control. Dirty plugs
may cause sound distortion or intermittent
breaks in the sound.
cloth to wipe the plugs of the headphones/
earphones or the remote control. Dirty plugs
may cause sound distortion or intermittent
breaks in the sound.
On batteries
Incorrect battery usage may lead to leakage of
battery fluid or bursting battery. To prevent
such accidents, observe the following
precautions:
battery fluid or bursting battery. To prevent
such accidents, observe the following
precautions:
•
Install the + and – poles of the batteries
correctly.
correctly.
•
Do not try to recharge dry battery.
•
When the recorder is not to be used for a long
time, be sure to remove the batteries.
time, be sure to remove the batteries.
•
If a battery leak should develop, carefully and
thoroughly wipe away battery fluid from the
battery compartment before inserting new
ones.
thoroughly wipe away battery fluid from the
battery compartment before inserting new
ones.
On mechanical noise
The recorder gives off mechanical noise while
operating, which is caused by the power-saving
system of the recorder and it is not a problem.
operating, which is caused by the power-saving
system of the recorder and it is not a problem.
To protect a recorded MD
To record-protect an MD, slide open the tab at
the side of the MD. In this position, the MD
cannot be recorded. To record again, slide the
tab back so the tab is visible.
the side of the MD. In this position, the MD
cannot be recorded. To record again, slide the
tab back so the tab is visible.
Back of the MD
Recorded material is
not protected.
not protected.
Tab
Recorded material is
protected.
protected.