ADIC SNC 5100 User Manual

Remove all devices from the SCSI buses.

Attach ONLY the device in question to the SCSI channel it was 
originally connected to using a known-good SCSI cable and 
terminators.

Power the SNC 5100 back on. Wait for it to finish booting. 

Enter the 

scsiShow

 command from the service terminal and verify 

the device’s presence.

For more information, see the 

If the device is missing from the display, it needs to be replaced 
and/or serviced. 

Inform the system administrator of any suspected bad devices 
found in this step.

Replace or remove any bad devices.

If the device is present, perform a health check.

For more information, see “Perform Health Check” on page 46.

Review the host event log. 

For more information, see “Check the Host Event Log” on page 47.

If SCSI errors are found, then inform the system administrator that 
the connected device appears to be bad. 

Replace or remove any bad devices.

After all possible device checks are performed go to 

.

Shut down the SNC 5100. 

Reconnect all available SCSI devices to their proper channel 
assignments.

Use the original configuration, except where changes have been 
made per this MAP.