ADIC SNC 5100 User Manual

If both addresses are the same, go to step 33.

Example:

SN60023 > gateAddrGet

Gateway Address set to 192.168.1.1

value = 0 = 0x0

If the network gateway address is incorrect, set it to the value 
provided by the network administrator using the 

gateAddrSet

 

command.

For more information, see the 

From the service terminal, enter the 

reboot

 command.

Wait until the SNC 5100 has finished booting.

From the service terminal, use the 

ping

 command to PING the IP 

address of the ADIC Management Console Server.

For more information, see the ADIC Management Console User 
Guide.

From the host running the ADIC Management Console Server, 
PING the SNC 5100.

If both PING tests succeed, exit this MAP.

If a PING test fails, inform the network administrator to check and 
correct the network connection, route tables, and network gateway 
addresses for both the ADIC Management Console Server and the 
SNC 5100.

These steps are performed if the SNC 5100 boots and responds to the ADIC 
Management Console, but the Service Port does not respond.

For more information, see the ADIC Management Console User Guide.