ADIC SNC 5100 User Manual

If the test passes, remove the loop back plug and go to 

.

If the test does not pass, go to “Start MAP” on page 42.

Attach the appropriate VHDCI cable between SCSI 1 and 2.

From the service terminal, enter the 

scsiChannelTest 1,2 

command.

For more information, see the 

If the test passes, remove the loop back cable and go to 

. 

If the test does not pass, go to “Start MAP” on page 42.

Attach the appropriate VHDCI loop back cable between SCSI 3 
and SCSI 4.

From the service terminal, enter the 

scsiChannelTest 3,4 

command.

For more information, see the 

If the test passes, remove the loop back cable and go to 

If the test does not pass, go to “Start MAP” on page 42.

For further information about the procedures and commands used in this 
section, see “Connecting to the Service Port” on page 95 and “Diagnostic 
Command Reference” on page 187.