ADIC FastStor Mass Storage Device User Manual

 

Introduction 

9

The data cartridges used in the DLT drive are housed in 4-inch plastic cases and employ ½-inch metal particle tape. 

WRITE-PROTECT

SWITCH

WRITE-ENABLED

WRITE-PROTECTED

BAR CODE LABEL

ORANGE

INDICATOR

 

The write-protect switch is used to prevent recording over existing data. To prevent recording or deleting, place the write-protect 
switch to the open position. The drive senses the position of the switch and will not allow writing in this position. When installing 
cartridges in the FastStor, place the switch in the closed position (unless you do not wish to record on a specific cartridge). 

If the switch is moved all the way to the left, the cartridge is write-protected and the drive cannot write to, or erase data from, the 
cartridge. The small orange rectangle will be visible whenever the cartridge is write-protected. Additionally, an arrow (beneath the 
orange rectangle and above the two lines on the switch) lets you know that data cannot be written to the cartridge. If the switch is 
moved all the way to the right, the cartridge is write-enabled and the drive can write data to, or erase data from, the cartridge. The 
orange rectangle will not be visible whenever the cartridge is write-enabled. On the right side of the write-protect switch an arrow 
over one line indicates that if you slide the switch to the right, data can be written to the cartridge. 

 

 

Store data cartridges in a dry, cool environment. 

 

 

Never reset or power down your computer or FastStor while a function is in process or a tape is moving.