Dish DuoDVR ViP 722k User Manual

Set up the remote to control other devices using the device codes listed on page 137. In 
the instructions below, the column on the left contains the instructions and the column on 
the right provides additional information.

1

Turn the device on.

Use the device’s front panel buttons or its remote 
control.

2

Find the brand name of the device in the 
tables starting on page 137. 

If the brand isn’t listed, see Setting Up Using Device 
Codes Scan on page 78.

3

Press and hold the mode button until all the 
other mode buttons light up, then release 
the button. The mode button flashes.

For example, for a TV, hold the 

TV

 mode button 

until all of the other mode buttons light. When you 
let go, TV will flash.

4

 mode only. Press 0 for a TV, 1 for 

a VCR, or 2 for a tuner or amplifier.

If you’re not programming in 

AUX

 mode, skip to 

step 5.

5

Enter one of the three-digit device codes 
from the table using the number buttons. 

The three-digit device code is for the brand name of 
your device that you found in step 2.

6

If you want to program Limited Mode, press 
1. If not, skip to step 7.

See Limited Mode for more information.

7

Press 

POUND

 (#). 

If you entered the code correctly, the mode button 
flashes three times.

8

Press 

POWER

 to turn off the device. If the 

device does not turn off, go to step 10.

If the code works, the device should turn off.

9

Turn the device back on and try some other 
buttons to make sure they work. If the code 
works for other buttons, stop here.

Sometimes 

POWER

 works when other buttons 

don’t. If in Limited Mode, try 

VOLUME

 or 

MUTE

.

10

If the code doesn’t work, repeat steps 3 
through 9 with another device code from 
the tables.

Try every code listed for your brand until one works 
for your device.

11

If you can’t find a code that works, try 
Setting Up Using Device Codes Scan that 
follows.