Dish DuoDVR ViP 722k User Manual
Remote Controls
81
Controlling Other Components
4
To start learning commands for this mode:
•
If you've found a code for that
device, first program the code.
Now press and release RECALL,
then hold RECORD for about three
seconds.
device, first program the code.
Now press and release RECALL,
then hold RECORD for about three
seconds.
•
If you have not programmed a
code for that device, press and
hold RECORD for three seconds.
code for that device, press and
hold RECORD for three seconds.
To find and program the device code, use the
instructions for Setting Up Using Device Code
Tables on page 77 or Setting Up Using Device
Codes Scan on page 78.
instructions for Setting Up Using Device Code
Tables on page 77 or Setting Up Using Device
Codes Scan on page 78.
The mode button that you selected remains lit
while learning.
while learning.
5
Point the front of the original device remote
to face the small square (IR window) on the
front, left-hand side of DISH Network’s
remote, as shown on page 80.
to face the small square (IR window) on the
front, left-hand side of DISH Network’s
remote, as shown on page 80.
6
On the DISH Network remote control,
press the button you want to teach.
press the button you want to teach.
7
On the original device remote control,
press and hold the button you want
learned.
press and hold the button you want
learned.
•
If the DISH Network remote learns
the command, the mode light
blinks off and then back on.
the command, the mode light
blinks off and then back on.
•
If the mode light blinks three times
or remains lit, the DISH Network
remote did not learn the command.
or remains lit, the DISH Network
remote did not learn the command.
You may need to try pressing the button on the
original device’s remote several times for the
DISH Network remote to learn the command.
original device’s remote several times for the
DISH Network remote to learn the command.
8
After a button has learned a command suc-
cessfully, repeat step 6 and step 7 until all
commands you want have been learned.
cessfully, repeat step 6 and step 7 until all
commands you want have been learned.
9
To end the learning sequence:
•
Press one of the mode buttons on
the DISH Network remote. This
saves all the commands for that
mode, and exits learning to return
to normal remote control operation.
the DISH Network remote. This
saves all the commands for that
mode, and exits learning to return
to normal remote control operation.
•
To cancel learning, do not press
any buttons on either remote
control for at least 30 seconds. The
DISH Network remote control
times out and returns to normal
operation.
Note that no learned commands
are saved if the DISH Network
remote control times out before
completion.
any buttons on either remote
control for at least 30 seconds. The
DISH Network remote control
times out and returns to normal
operation.
Note that no learned commands
are saved if the DISH Network
remote control times out before
completion.
The learning sequence also ends:
•
If the remote runs out of memory
for learned commands, it saves the
commands you have learned for
equipment in this mode, exits
learning and returns to normal
remote control operation. The
DISH Network remote cannot learn
additional commands.
for learned commands, it saves the
commands you have learned for
equipment in this mode, exits
learning and returns to normal
remote control operation. The
DISH Network remote cannot learn
additional commands.
•
If the remote control batteries are
too low for learning, all the mode
buttons blink quickly eight times.
Learning ends with no learned
commands saved, and the DISH
Network remote returns to normal
operation.
Change the batteries.
too low for learning, all the mode
buttons blink quickly eight times.
Learning ends with no learned
commands saved, and the DISH
Network remote returns to normal
operation.
Change the batteries.