Dish ViP722k Owner's Manual

Shared View is a feature of Single Mode on your receiver that lets you activate the TV2 
audio and video outputs to display the same programming as the TV1 outputs. While 
using this feature, both Remote Control 1 and Remote Control 2 for your satellite receiver 
can control what is displayed on all TVs connected to the system. This feature is available 
only while in Single Mode.

Make sure the receiver is in Single Mode.

Press MENU, select System Setup and then Shared View.

Select Enable View or Disable View.

Select Done.

Note: Make sure you are using Remote Control 1 and TV1 because you cannot enable or 
disable this feature while using Remote Control 2.

Note: If you do not want to display programming on any TV besides TV1 and you do not 
want Remote Control 2 to control the receiver, select Disable View. After you select 
Done, TV2 will show a screen in Single Mode that says Shared View is currently disabled.

If you have TV1 and TV2 connected to the receiver with coaxial cables (see page 115), 
you can decide which channel you’d like to use to view your DISH programming on each 
TV. Use Remote Control 1 to view or change this setting on TV1. If you have locked the 
receiver, then you’ll have to enter the password to enable TV1’s output on the screen. 
Make sure that each TV connected to your system is able to tune to the specific channel 
you choose for it before you finish changing the setting on this screen. If more than one TV 
is connected to TV2 outputs, all these TVs must be able to be tuned to the channel chosen 
for TV2 output.