DeWALT 50-665 Instruction Manual

ON/OFF SWITCH

The ON/OFF switch is conveniently located on the side

of the motor.To turn the dust collector ON push the

switch (A) Fig. 22, upward to the ON position. To turn

the dust collector OFF , push the switch down to the

OFF position.

CONNECTING DUST C O L L E C TOR TO

P O W E R S O U R C E

Before connecting your dust collector to an electrical power system, be sure the motor rating

agrees with the electrical system it is to be connected to.

Fig. 20

Fig. 21

Fig. 22

SINGLE P H A S E O P E R ATION

If the motor on your dust collector is wired for 115 Volt,

single phase, the power cord is equipped with a plug that

has two flat, parallel current-carrying prongs, and one

longer round or U shaped ground prong which requires

a mating 3-conductor grounded type receptacle, as

shown in Fig. 20.

If the motor on your dust collector is wired for 230 Volt,

single phase, the power cord is equipped with a plug that

has two flat, current-carrying prongs in tandem, and one

round or U shaped longer ground prong. This is used

only with the proper mating 3-conductor grounding type

receptacle, as shown in Fig. 21.

When the three-prong plug on your dust collector is

plugged into a grounded 3-conductor receptacle, the

long ground prong on the plug contacts first so the

machine is properly grounded before electricity reaches it.

CAUTION: IN ALL CASES, MAKE C E R TAIN T H E RE-

CEPTA C L E IN QUESTION IS P R O P E R LY GROUNDED.

IF Y O U A R E N O T S U R E,H AV E A CERTIFIED E L E C-

TRICIAN CHECK T H E RECEPTA C L E.