Digicom COMSPHERE 3911 User Manual

September 1998

3910-A2-GN32-40

NMS_Call_Msgs:  CallCnct&Prg
Nxt   CallCnct&Prg   Disable   CallCnctOnly   CallProgOnly

NMS Call Messages. Determines if the modem status and/or call summary information is sent to the NMS.
The modem can itemize status, such as CallProgress messages, or it can report a summary of activity, such
as Call Connect messages, to the NMS.

H

Call Connect & Progress

Enables both Call Connect and Call Progress information to be transmitted to the NMS.

H

Disable

Modem status and call summary information is not sent to the NMS.

H

Call Connect Only

The modem accumulates call statistics over a period of time and then transmits a summary of these
statistics to the NMS. The NMS uses this data to produce utilization reports.

H

Call Progress Only

The modem transmits detailed modem status information to the NMS. These messages include any
events that can display on the LCD.

NOTE: For 6800 Series NMS applications, Disable must be selected.

The AT commands are S-Register S66=n where n is 0 for Call Connect & Progress, 1 for Disable, 2 for Call
Connect Only, and 3 for Call Progress Only.

NetworkPosition:  Tributary
End   Tributary   Control

Network Position Identification. Each modem must be identified either as a control modem or a tributary
modem.

NOTE: Changes to this configuration option will cause the modem to reset.

NOTE: This configuration option is only applicable for leased-line network management applications.

For the Model 3910, Tributary is the factory default.
For the Model 3911, Control is the factory default.

The AT command for Tributary is S74=0.
The AT command for Control is S74=1.

NetMngmtAddress:  256
Nxt   

"

   256

Network Management Address. Determines the address used when accessing a modem from the NMS or
when using DCP functions that require network management addresses. Within a network link, a control
modem can communicate with a tributary modem by using the tributary modem’s network management
address. Each tributary modem must have a different network management address.

NOTE: Changes to this configuration option will cause the modem to reset.

NOTE: A point-to-point tributary is always Address 1.

Address values range from 001 to 256.

The AT command is S-Register S75=n, where n is a value from 0 to 255 (001 to 256).