Digicom COMSPHERE 3911 User Manual

3910-A2-GN32-40

September 1998

From the Choose DLL Type screen, press the  

  key until DC_Broadcast appears. Press F1 or

F2  to transfer an exact copy of the tributary modem’s firmware to the DC-connected control
modem(s) using the Active Poll list.

Proceed to Implementing a Clone Remote Operation on page 7-12, which follows the
descriptions of multipoint cloning operations.

F1

Choose DLL Type >
DC_CloneResults

F2

F3

From the Choose DLL Type screen, press the  

  key until DC_CloneResults appears to view

the results of the last DC_Broadcast clone operation. If the message Trib List Empty appears,
this indicates that a multiple download was never initiated.

F1

DC Clone Results
Nxt    xxx    Pass

F2

F3

The address field (xxx) displays the network management address of one of the remote modems.
Pressing the F1 key allows you to select various remote modems to determine the download
result for those modems (Pass or Fail).

A Trellis Multipoint (TMp) control modem can be used to download firmware to just one
tributary modem (Single) or to all of its tributary modems (Multiple).

A Trellis Multipoint (TMp)

 

tributary modem cannot download

firmware to its control modem. To download firmware to a TMp
control modem use a point-to-point dial connection, an NMS, or a
PC controller.

Before using Clone Remote in multipoint configurations (Single or Multiple), perform the
following:

•

Make sure the 391x Series modems have an established leased-line connection using the
Trellis Multipoint (TMp) modulation (refer to Leased Line in Chapter 5, DCP
Configuration).

•

Make sure the remote modem’s Access From Remote configuration option is enabled
(refer to Misc in Chapter 5, DCP Configuration).