Digicom COMSPHERE 3911 User Manual

3910-A2-GN32-40

September 1998

S47

Auto Dial Standby. Register determines if the modem performs an
automatic dial standby if in Dial Backup mode.

Register has the following values:

0 = Disable
1 = 15 minutes
2 = 1 hour
3 = 4 hours
4 = Test(2min)
5 = Adv 15min
6 = Adv 30min
7 = Adv 1 hr
8 = Adv2minTest

The factory setting is Disable.

Configure\Edit\
Leased Line

S48

Leased-Line Carrier On Level. Register determines if the modem
disconnects if the carrier signal on leased lines falls below –26 dBm or
– 43 dBm.

Register has the following values:

0 = – 43 dBm
1 = –26 dBm
2 = –33 dBm

The factory setting is country dependent (usually – 43 dBm). In France,
the factory setting is –26 dBm in 4-wire operation and –33 dBm in
2-wire operation.

Configure\Edit\
Leased Line

S49

Buffer Disconnect Delay. Register determines how long the modem
continues to transmit data stored in its buffers when the modem is
commanded to disconnect by a locally attached DTE.

Enter a value from 0–255 seconds. (A value of 0 disables this
register.) The factory setting is 10 seconds.

Configure\Edit\
V42/MNP/Buffer

S51

DTE RL (CT140). Register determines if the modem performs a
remote digital loopback if it receives a CT140 signal from the DTE.

Register has the following values:

0 = Disable
1 = Enable

The factory setting is Disable.

Configure\Edit\
Tests

S52

DTE LL (CT141). Register determines if the modem performs a local
analog loopback if it receives a CT141 signal from the DTE.

Register has the following values:

0 = Disable
1 = Enable

The factory setting is Disable.

Configure\Edit\

 Tests