Digicom COMSPHERE 3911 User Manual
COMSPHERE 3900 Series Modems
2-2
September 1998
3910-A2-GN32-40
Customer-Supplied Equipment
The following customer-supplied equipment is required to complete a data communications system
using the Model 3910 modem:
using the Model 3910 modem:
•
A DTE with an available EIA-232-D serial port.
•
A standard EIA-232-D cable with a DB-25-P (plug) connector at one end to attach to the
modem.
modem.
•
One of the following modular leased or dial network interfaces:
— JM8 for leased-line applications.
— RJ11C for dial permissive applications.
The following customer-supplied equipment is required for the installation of a Model 3911
modem:
modem:
•
A COMSPHERE 3000 Series Carrier.
•
A 50-pin mass termination cable.
•
One of the following modular or 50-pin leased or dial network interfaces:
— RJ11C for single line dial permissive applications.
— RJ21X for multiple line dial permissive applications.
— 66 punchdown block.
•
One Network Interface Module (NIM) for modems installed in Slots 1–8 and one NIM for
modems installed in Slots 9–16 (required for dial-line applications).
modems installed in Slots 9–16 (required for dial-line applications).
For installation of the COMSPHERE 3000 Series Carrier into a cabinet, refer to the COMSPHERE
3000 Series Carrier, Installation Manual.
3000 Series Carrier, Installation Manual.
Model 3910 Modem Installation
Before installing your standalone modem, make sure your installation site is clean and
well-ventilated. Allow space around the modem for installing cables and telephone cords, and
make sure the modem is located within reach of the ac power outlet. The distance between your
modem and DTE should be minimized if DTE data rates exceed 19,200 bps. Also, low capacitance
cables may be necessary for speeds greater than 19,200 bps or distances greater than 50 feet.
well-ventilated. Allow space around the modem for installing cables and telephone cords, and
make sure the modem is located within reach of the ac power outlet. The distance between your
modem and DTE should be minimized if DTE data rates exceed 19,200 bps. Also, low capacitance
cables may be necessary for speeds greater than 19,200 bps or distances greater than 50 feet.
The rear panel of the Model 3910 modem (Figure 2-1) has the following switches and connectors:
•
An ON/OFF power switch.
•
An 8-pin DIN type power receptacle (PWR) for the dc power supply.
•
An 8-pin modular keyed jack (LEASED) for 4-wire/2-wire leased lines.
•
An 8-pin modular keyed jack (DIAL) for backup lines (2-wire dial or 2-wire leased).
•
A 4-pin modular jack for the (NMS) network management system connection.
•
A 25-pin DB-25-S receptacle for the DTE interface.