Manualsbrain.com
  1. Manuals
  2. Brands
  3. Digicom
  4. COMSPHERE 3911
  5. User Manual

Digicom COMSPHERE 3911 User Manual

Download
Page of 280
COMSPHERE 3900 Series Modems
4-4
September 1998
3910-A2-GN32-40
Table 4-1
(2 of 2)
Health and Status Messages
Type
Indicates
Message
Dial
Make Busy Mode
The modem is in a Make Busy condition.
Service Line
(Model 3911 only) The modem installed in a COMSPHERE 3000
Series Carrier has been switched to a service line.
Short Hold Time
The modem’s dial hold time has been shortened.
Non-Answering
The modem is in a non-answering mode.
Thresh*
RSL High
Threshd
The received signal level (RSL) has exceeded the upper threshold.
RSL Low
Threshld
The RSL is less than the lower threshold.
SNR Threshold
The signal-to-noise ratio has exceeded the threshold.
Non-linear Dist
The non-linear distortion has exceeded the threshold.
Retrains
The number of retrains has exceeded the threshold.
Signal Quality
The signal quality is less than the threshold.
Far Echo Threshd
The far end echo level has exceeded the threshold.
Near Echo Thresh
The near end echo level has exceeded the threshold.
Security
Database Reset
The security database has been reset (passwords erased).
y
Password Protect
Security password protection has been enabled.
Mode Change
There has been a change in security mode. (Refer to Chapter 12, Dial
Access Security.)
Password
Change
A security password has been changed.
Database Change
The security database containing passwords has been changed.
Port 1
Rx Data Alarm
The DTE port’s RXD signal is in an alarm condition.
Tx Data Alarm
The DTE port’s TXD signal is in an alarm condition.
DTR Alarm
The DTE port’s DTR signal is in an alarm condition.
CTS Alarm
The DTE port’s CTS signal is in an alarm condition.
RTS Alarm
The DTE port’s RTS signal is in an alarm condition.
DSR Alarm
The DTE port’s DSR signal is in an alarm condition.
LSD Alarm
The DTE port’s LSD signal is in an alarm condition.
Auto Stream Dis
The modem is in an Antistreaming condition. (Refer to the Streaming
DTE message in the Major Alarm section of this table.)
Disabled
The modem’s DTE port has been disabled.
*Not supported in every modulation.
To exit DeviceHS and remain in the Status Branch, press the  
  key. To exit and return to the
Top-Level menu, press the  
  key.