Denso BHT-7500 User Manual
79
Chapter 2. Getting Started the BHT and System Mode
Testing the optical interface port
Selecting the "1:OPTICAL" on the TEST COMMU-
NICATION menu calls up the screen shown at left.
NICATION menu calls up the screen shown at left.
At the slave BHT to be tested, select the "1:SLAVE"
and at the master BHT, select the "2:MASTER."
Then press the ENT key on each BHT.
and at the master BHT, select the "2:MASTER."
Then press the ENT key on each BHT.
During the test, the screen shown at left is dis-
played.
played.
If any error occurs, the tested slave BHT beeps
three times and shows the screen at left.
three times and shows the screen at left.
In parentheses are error codes which have the
following meanings:
following meanings:
(X X)
1: The received data is different from
the sent data.
2: A timeout has occurred during
standby for data reception.
1: 2400 bps
2: 9600 bps
3: 115200 bps
2: 9600 bps
3: 115200 bps
Press the C key to return to the TEST COMMUNI-
CATION menu.
CATION menu.
The master BHT will automatically return to the
TEST COMMUNICATION menu after 10 seconds
from the occurrence of an error.
TEST COMMUNICATION menu after 10 seconds
from the occurrence of an error.
TEST COMMUNICATION
< OPTICAL >
1:SLAVE
2:MASTER
TEST COMMUNICATION
< OPTICAL >
** Testing **
TEST COMMUNICATION
< OPTICAL >
** Test NG **
(XX)