Denso BHT-7000 User Manual

40

Selecting "2: DOWNLOAD" on the SYSTEM MENU
calls up the screen shown at left.

 1  FILE

:

Downloads a user program
file  or  data  file  to  the  user
area of the BHT-7000.

 2  HT<-->HT COPY :

Downloads  all  of  the  files,
system parameters, and cal-
endar  clock  data  stored  in
the connected BHT-7000.

This function enables copy-
ing between the BHT-7000s.

For  the  preparation  to  be
made preceding the start of
this function, refer to NOTE
below.

Select a desired item by using the numerical keys
or 

*  and 

*  keys,  and  the  selected  item  be-

comes highlighted.  Then press the  ENT  key.

To return to the SYSTEM MENU, press the  C  key.

If you download a file having the same name as one already used in the user area of
the target memory in the BHT-7000, the newly downloaded file replaces the old
one.

NOTE

Preparation for Copying between the BHTs

Before downloading to the BHT-7000 from another BHT-7000, make the fol-
lowing preparation:

• At each BHT-7000, set the interface port.  The default is an optical interface

(Optical).

Interface setting procedure:  Starting on the SYSTEM MENU, select "4:SET
SYSTEM," "5:COMMUNICATION," and "3:COM PORT."  On the SET COM
DEFAULT PORT screen, select the optical interface (Optical) or direct-con-
nect interface (Connector) of "2:SYSTEM MODE."

• When using the direct-connect interface, pull out the connector cover on

each BHT-7000 to expose the direct-connect interface port.  Connect the
BHT-7000s via those ports with the direct-connect interface cable (having 3-
pole mini stereo plugs).  For the details about the cable, refer to Chapter 3,
Section 3.1.

• On the uploading BHT-7000, run System Mode and select "3:UPLOAD" and

"3:HT<-->HT COPY."

      DOWNLOAD

   

1:FILE

   2:HT<-->HT COPY

* For BHT-7000s having a 26-key pad, use   F5  ,   F6  ,   F7   and   F8   keys instead of 

, 

,

, and 

 keys, respectively