DELL N4000 Series Technical Manual
13
SCG1001
Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide
console(config-if)#exit
console(config)#interface range fortygigabitethernet 1/0/1-2
Note: Port numbering for the 40Gb QSFP ports may vary by switch model and module configuration.
Confirm the correct port range for your configuration.
Confirm the correct port range for your configuration.
console(config-if)#datacenter-bridging
console(config-if-dcb)#priority-flow-control mode on
console(config-if-dcb)#priority-flow-control priority 4 no-drop
console(config-if-dcb)#exit
console(config-if)#switchport mode trunk
console(config-if)#exit
console(config)#interface port-channel 1
console(config-if-Po1)#switchport mode trunk
console(config-if-Po1)#exit
3.5
Configure ETS values
console(config)#
traffic-class-group weight 50 50 0
Note: This command uses an example of 50% non-iSCSI traffic (first parameter) and 50% iSCSI traffic
(second parameter). The sum of the bandwidth-percentages must be equal to 100.
(second parameter). The sum of the bandwidth-percentages must be equal to 100.
console(config)#exit
3.6
Save configuration
console# copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y