DeLonghi Gran Dama Avant ESAM 6700 Instruction Manual
21
DISpLAyED mESSAGES
DISpLAyED mESSAGE poSSIBLE CAuSE
rEmEDy
FILL TANK!
•
The water tank is empty or positioned
incorrectly.
•
Fill the tank with water and/or insert it
correctly, pushing it as far as it will go.
GROUND TOO FINE
ADJUST MILL!
Insert water spout and
press OK
•
The grinding is too fine and the coffee is
delivered too slowly.
•
Make the coffee again and turn the
grinding adjustment knob one click
clockwise towards “7” while the coffee
mill is in operation. The effect is only
visible after delivering two coffees.
•
The machine cannot make coffee as
there is air in the hydraulic circuit
•
Press the oK icon to deliver water from
the spout until it flows out normally.
INSERT WATER
SPOUT!
•
The water spout is not inserted or is
inserted incorrectly.
•
Insert water spout as far as it will go.
EMPTY GROUNDS
CONTAINER
•
The grounds container is too full or
more than 3 days have passed since you
last made coffee (this guarantees correct
hygiene of the machine).
•
Empty the grounds container and clean,
then replace.
Important: when removing the drip tray,
the grounds container MUST be emptied,
even if it is not completely full.
If this is not done, when you make the
next coffees, the grounds container may
fill up more than expected and clog the
machine.
INSERT GROUNDS
CONTAINER
•
After cleaning, the grounds container
has not been replaced.
•
Open the service door and insert the
grounds container.
If grounds container is inside the
machine and message is still displayed,
there may be a damaged mircoswitch
and customer service should be called.
INSERT MILK
CONTAINER!
•
The milk container is not inserted. .
•
Insert milk container as far as it will go.
DESCALE!
•
The machine must be descaled.
•
The descaling procedure described in
the “Descaling” section needs to be
performed as soon as possible.
LESS COFFEE!
•
Too much ground coffee has been used. •
Select a milder taste or reduce the
quantity of pre-ground coffee, then make
the coffee again.
ADD PRE-GROUND
COFFEE!
•
The “pre-ground coffee” function has
been selected without placing any pre-
ground coffee in the funnel.
•
Place pre-ground coffee in the funnel.
•
The funnel (A8) is blocked.
•
Empty the funnel with the help of a
dull knife, as described in the section
“Cleaning the pre-ground coffee feed
funnel”.
FILL BEANS
CONTAINER!
•
The coffee beans have run out.
•
Fill bean container
INSERT BREW GROUP
ASSEMBLY!
•
The brew group has not been replaced
after cleaning.
•
Insert the brew group as described in the
section “Cleaning the brew group”.
CLOSE DOOR!
•
The service door is open
•
Close the service door.